Impulse 2803 Manual de usuario

SeaLINK+8/USB TM Part # 280XSealevel Systems, Inc P.O. Box 830 Liberty, SC 29657 USA Phone: (864) 843-4343 FAX: (864) 843-3067 www.sealevel.co

Specifications Sealevel Systems SeaLINK+8 Page 8 Technical Description The SeaLINK+8 utilizes eight USB UARTs. These chips feature programmable baud

Specifications Sealevel Systems SeaLINK+8 Page 9 Specifications Environmental Specifications Specification Operating Storage Temperature Range 0º t

Appendix A – Troubleshooting Sealevel Systems SeaLINK+8 Page 10 Appendix A - Troubleshooting Serial Utility test software is supplied with the Seal

Appendix B – How To Get Assistance Sealevel Systems SeaLINK+8 Page 11 Appendix B - How To Get Assistance Please refer to Appendix A - Troubleshoo

Appendix C - Electrical Interface Sealevel Systems SeaLINK+8 Page 12 Appendix C - Electrical Interface RS-232 Quite possibly the most widely used c

Appendix C - Electrical Interface Sealevel Systems SeaLINK+8 Page 13 RS-485 RS-485 is backwardly compatible with RS-422; however, it is optimized f

Appendix D - Asynchronous Communications Appendix D - Asynchronous Communications Serial data communications implies that individual bits of a cha

Appendix E - Compliance Notices Appendix E - Compliance Notices Federal Communications Commission Statement FCC - This equipment has been tested an

Warranty Warranty Sealevel Systems, Inc. provides a lifetime warranty for this product. Should this product fail to be in good working order at any

Contents INTRODUCTION... 1 INSTALLATION INSTRUCTIONS...

Introduction Sealevel Systems SeaLINK+8 Page 1 Introduction Overview The Sealevel Systems SeaLINK+8 family of products equips the PC with 8 USB to

Installation Installation Instructions Windows 98/ME/2000/XP/Vista™ Operating Systems Do not connect the device to a USB port until the software i

Installation Sealevel Systems SeaLINK+8 Page 3 Physical Installation The screen captures below are taken from a Windows 98 installation. Your part

Installation You can access your new COM: ports by using the assigned COM: identifiers as shown above. In this case, it is COM’s 12 thru 19. Ho

Configuration Sealevel Systems SeaLINK+8 Page 5 Configuration Factory configuration Each device ships from Sealevel Systems with the following conf

Configuration Below is a figure of dipswitches SW1, SW2, SW3, and SW4. Each switch has a total of twelve positions and serves to configure two port

Configuration Interface Biasing Configuration The last four positions for each port are used to select the line termination and bias settings. Refe